FORM FIT HD 20C 05 Manual

FORM FIT
Toyota Avalon 2005 -
Hardware Kit
4 – Large Bumpons
4 – 3M Anti-abrasion Film Pads
4 – Black 'C' Clips
4 – #6 x 3/8" Screws
4 – #4 x 3/16" Screws
1 – 38" X 3/8" Roll Gasket

Installation

1. Be sure that the hood is clean and dry inside and out. Open the hood of the vehicle.
2. Start peeling the backing from the roll gasket material and attach it under side of chrome strip mounted on the leading edge of the hood, as shown in
illustration #1. Trim the gasket at both ends with scissors if necessary.
3. Install the bumpons as shown in Illustration #2. Attention: The bumpons must be installed on the hood, not on the protector!!!. If the bumpons are
installed on the protector, they will wear through the paint.
4. Center the protector on the hood, resting on the bumpons.
5. Peel and fold an anti-abrasion film pad in half over the edge of the hood, underneath each of the two (2) inner holes in the protector. See Illustration #3.
6. Slide the "C" clips on the hood in line with the holes in the protector. Be sure that the "C" clips are well seated against the hood; it may be necessary to tap
on the clips. See Illustration #3.
7. Be sure that the hole in the top of the clips lines up with the hole in the protector, then tighten the #6 x 3/8" screws, through the protector and into the top of
the "C" clips. Do not over tighten. See Illustration #3.
8. Make sure all the clips are well seated against the hood. Tighten the #4 x 3/16'' screws in the back of the "C" clips. See Illustration #3.
9. Repeat steps #5, 6, 7 and #8 for the other two (2) holes.
10. On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.
Note: Do not pull on the protector when opening or closing the hood.

Care Instruction

Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents. Periodically check to make
sure that the bumpons are in place and that the protector is secure. Avoid using automatic car washes. Do not pull on the protector when opening or
closing the hood.

Illustration #1: Gasket Location

Hood
Protective Gasket

Illustration #3: Clip Location and Configuration

Thank you for purchasing a form fit hood protector.
Retain this sheet for care instructions and kit information
Made in Canada
HOOD PROTECTOR
Bumpons Location
Under the Protector
Protector
Chrome Strip
Clips (Step #9)
Clips (Step #5 & 6)
Tools Required
1 – Phillips Screwdriver #1 & #2
1 – Tape Measure
1 – Scissors

Illustration #2: Bumpon Location

15"
5"
HD 20C 05
15"
¾"
5"
5"
Rev0.050124