FORM FIT HD-13A13 Installation Instructions Manual

Form Fit
Hood Protector
Installation instructions
PARTS LIST
Hood Protector
Large Pedestals (3)
Large Bumpons (2)
Small Pedestals (4)
2 with fingers/ 2 without fingers
Pins (7)
# 6 x 5/8 Flat Head Screws (7)
Anti-abrasion Film Pads (5)
Large Metal Mounting Brackets (3)
Small Metal Mounting Brackets (2)
Alcohol Wipes (1)
Tape strip sheet (repositionable) (1)
TOOLS AND SUPPLIES REQUIRED
Long Shank Phillips Screwdriver #2
Tape Measure
Grease Pencil
Masking Tape
Nissan Altima 2013-up
INSTALLATION
·
Make sure the vehicle is clean and completely dry before
installation.
·
This product uses a 3M adhesive product that requires
installation and curing temperatures of at least 20°C/ 70°F
for 24 hours to develop maximum adhesion to the surface.
Failure to install this product at the proper temperature or
allow adequate curing time before use is not covered under
warranty.
·
Proper installation of the adhesive pedestal system
requires the use of a #2 Phillips screwdriver, preferably
with a long shaft. The shaft of the screwdriver needs to
fit through the hole in the pedestal. Use of the correct
screw driver will facilitate a trouble free installation. Do
not attempt to use #1 or smaller Phillips screwdriver or
any type of electric screwdriver.
13. Using a tape measure and grease pencil, mark the
center of the hood.
·
Use the picture below to help in finding centre, you can
verify by using feature lines on the hood or
symmetrical holes on the underside of the hood to
achieve this; however it is important to use a tape
measure for accurate placement.
2. Dry fit the adhesive pedestals using masking tape or the
repositionable tape strips supplied to hold them in
position. See the next page for order and positions of
the adhesive pedestals.
Large Pedestal
NOTE: The 9mm hole
in the back of pedestal
is to accommodate the
shaft of the screwdriver
Rev0.030315
HD-13A13
Small Pedestal
without fingers
Small Pedestal
with fingers
HD 13A13 1 of 10