Advertisement
Table of Contents
Installation Instructions
KIT CONTENTS
Adhesive pedestals (5)
Surface cleaner (1)
Foam "D" seal (1)
Re-usable tape
strips (1)
Screws (9)
Installation tape measure (1)
Hood protector blade (1)
Tools and Supplies
Phillips Screwdriver # 2
Clean cloth or paper towel
Hood Protector
Toyota Tundra 2014- Up
Pins (9)
"L" Brackets (4)
Anti-abrasion pads (4)
Bumpons (2)
Clip bodies (4)
HD 20J14 Rev0.140718
HD 20J14
1of 7
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for FORM FIT HD 20J14
Summary of Contents for FORM FIT HD 20J14
- Page 1 Foam “D” seal (1) Anti-abrasion pads (4) Re-usable tape Bumpons (2) strips (1) Clip bodies (4) Screws (9) Installation tape measure (1) Hood protector blade (1) Tools and Supplies Phillips Screwdriver # 2 Clean cloth or paper towel HD 20J14 Rev0.140718 1of 7...
- Page 2 See illustration. 5. Install the two (2) bumpons as shown. Attention: Bumpons must be installed on the hood, not on the protector!!! If the bumpons are installed on the protector, they may wear through the paint. HD 20J14 Rev0.140718 2of 7...
- Page 3 7. Place the hood deflector on the pedestals to confirm proper positioning, make any necessary adjustments. WARNING: Do not adjust pedestal forward or back, left and right only! HD 20J14 Rev0.140718 3of 7...
- Page 4 10mm 10mm The hood protector does not sit on the Foam “D” seal when correctly installed. Foam “D” Seal Foam “D” Seal Trim here Start here HD 20J14 Rev0.140718 4of 7...
- Page 5 13. Start a screw into each pedestal a few turns. The tip of the screw must not protrude into the hole where the attachment pin will install later. 14. At the pedestal locations, drop a pin through the protector and into the pedestal. HD 20J14 Rev0.140718 5of 7...
- Page 6 17. Place a clip over each of the anti- abrasion film pads on the edge of the hood. 18. Insert a pin through the protector into each of the clips. HD 20J14 Rev0.140718 6of 7...
- Page 7 Do not use chemicals or solvents. Periodically check to make sure the Bumpons are in place and the protector is secure. Avoid using automatic car washes. Do not pull on the protector when opening or closing the hood. HD 20J14 Rev0.140718 7of 7...
Need help?
Do you have a question about the HD 20J14 and is the answer not in the manual?
Questions and answers