Fcc Statement To The User; Fcc Radiation Exposure Statement; Compliance Information - TiVo BOLT Series Viewer's Manual

FCC STATEMENT TO THE USER

Relevant safety and compliance information can be found at tivo.com/safety-compliance.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.

FCC RADIATION EXPOSURE STATEMENT

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End
users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain
compliance with FCC RF exposure compliance requirements, please follow operation instructions as
documented in this manual.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This
equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your
body.
The availability of some specific channels and/or operational frequency bands are country dependent and are
firmware programmed at the factory to match the intended destination. The firmware setting is not accessible
by the end user.

COMPLIANCE INFORMATION

Model numbers: TCD849500 (BOLT 500GB), TCD849000 (BOLT 1TB), RC30A00, RC30B00 (BOLT Remote)
TCD846000 (Roamio OTA), TCD846500 (Roamio), TCD848000 (Roamio Plus); TCD840300 (Roamio Pro); RC30A00,
RC30B00 (Remote), TCDA92000, TCDA93000 (Mini), TCDA94000 (Stream)
FCC IDs: TGN-TCD8495 (BOLT), TGN-RC30 (BOLT Remote), RAXWN8722BTAAC (BOLT Wi-Fi board) TGN-
TCDA93000 (Mini), TGN-TCD8465 (Roamio), TGN-TCD8400 (Roamio Plus/Pro), TGN-RC30 (Remote)
Askey International Corporation
800 Corporate Way, Suite B
Fremont, CA 94538
Model numbers: WLU5054 (Roamio), WLU5200 (Roamio Plus/Pro)
FCC IDs: H8N-WLU5054 (Roamio), H8N-WLU5200 (Roamio Plus/Pro)
TiVo Inc.
2160 Gold Street
San Jose, CA 95002