Bench Stand - GE Druck DPI 150 User Manual

Procedure
To fit this option requires a panel cut-out of the dimensions shown in
1. Remove the rubber inserts in the feet of the instrument.
2. Unscrew and remove two 45mm screws (2) attaching two feet on one
side of the instrument casing. Retain the two 45mm screws for the
next step.
3. Fit the side plate (1) to the side of the instrument casing and secure
with the two 45mm screws.
4. Repeat steps 2 and 3 for the other side plate.
5. Locate the assembled instrument behind the cut-out panel and align
the four 3.5mm holes in the panel and the holes in the flanges of the
side plates (1).
6. Locate the front plate (3) over the front of the protruding instrument
and secure the front plate with the four screws (4).

Bench stand

The bench stand lifts the front of the instrument providing a better angle of
display and key-pad access for the user.
1 stand
2 screw 45 mm
3 foot
4 clip, (left and right)
5 insert, rubber
Druck DPI 150 User Manual
Key to
5
2a
.
K344 Issue No. 2