Table of Contents
Advertisement
Maintenance
4.4
Check the standard settings
The spray gun has a factory setting for generating an optimum spray pattern with any
standard powder:
Input air pressure:
Powder output quantity:
Type of powder:
•
Check the input air pressure and readjust if necessary.
•
Check the fluid base of the powder container for damage and replace with a new one if
necessary.
L
K
Caution
The spindles M and N should be never screwed in completely
(Danger of destruction!).
The spray pattern can be reset if necessary by adjusting the dosing air M and/or atomizing air
N.
Hint
At a desired powder output of more than 200 g/min increase the input air pressure of the
spray gun at the control unit to max. 58 psi (4 bar):
• The powder output can get to a maximum of 300 g/min.
• Normally the dosage air M and the atomizing air N have not to be adjusted.
03/2003
PEM-CG3
max. 29 psi (2 bar)
max. 200 g/min
Standard powder with a grit size distribution of
35 ... 40% < 32 µm
K Set feed air 1)
L
Set fluid air 1)
M
M Set dosage air 1)
N Set atomizing air 1)
N
1) Turning counter-clockwise the value is increased.
15
0351713
Advertisement
Table of Contents
