Table of Contents
Advertisement
Projection Gun novaG-M
Service Manual
38. Fit the PCD on the module and press until the interior side makes contact with the front of
the module.
If you have fitted a PCD for flat fan, remember to turn the groove to the preferred projecting
position (see Figure. 17 and Figure. 18, page 15).
39. Fit the tightening nut of the PCD by hand, turning it clockwise. Make sure the groove does
not move out of position while tightening.
40. Make sure that the length that stands out of the chamber needle is correct, otherwise it
must be adjusted (see Figure. 4, page 9).
Adjust the needle as indicated in point 8 of Installation and Start-up (see page 9).
41. Fit the diffuser by hand, turning it clockwise.
42. Fit the seals of the coupling block in place and fix it to the gun mixing block.
43. Follow the instructions of points 9 to 13 of the Installation and Start-up (see page 10 and
11).
23/28
1.5 Issue
http://www.novag.eu/
Ref. NR-00018-ENG
Advertisement
Table of Contents
