Table of Contents
Advertisement
Projection Gun novaG-M
Service Manual
PRECAUTION!
Use wooden or plastic utensils or a brass brush for cleaning. Do not
use metal utensils that can scratch the surface.
11. Check the cartridge seal. Replace it if it is worn or damaged.
12. Grease all of the components and refit them in the cartridge.
13. Screw the isocyanate cartridge unit into its housing until it blocks. Make sure it is correctly
tightened to avoid product leaks.
14. Do the same with the polyol cartridge.
15. Carry out the projection procedure indicated in the section on Installation and Start-up (see
page 8).
16. Start the gun.
19/28
1.5 Issue
http://www.novag.eu/
Ref. NR-00018-ENG
Advertisement
Table of Contents
