11. Hand tighten the tightening nut of the PCD, clockwise. Make sure the groove does not move
out of position while tightening.
12. Adjust the needle as indicated in point 8 of Installation and Start-up (see page 9).
13. Hand fit the diffuser, turning it clockwise
14. Follow the instructions of points 9 to 13 of the Installation and Start-up (see page 10 and
page 11).
16/28
1.5 Issue
http://www.novag.eu/
Projection Gun novaG-M
Service Manual
Ref. NR-00018-ENG