Input Selection; Level Trim - a-them AVM 90 Operating Manual

7.3 INPUT SELECTION

The number of active inputs varies according to how the Input Setup menu was programmed. To scroll through the
active inputs, press PREV/INPUT or NEXT/INPUT on the front panel or press the right/left buttons on the remote, and to
make a selection press SELECT.
Front Panel Remote
Alternatively, press the INPUT button for an on-screen list of inputs. Use the up/down and SELECT buttons to change
the input.
To select the next input in Zone 2, press the INPUT button (after pressing the ZONE button if using the front panel).

7.4 LEVEL TRIM

If a channel group, for example, the surrounds or the subwoofer, occasionally sounds too loud or soft, adjust its level
on the fly—press LEVEL on the remote to cycle through the groups then up/down to adjust. Note, LFE is a separate
adjustment from the subwoofer. LFE can be used to reduce the level of LFE effects on multichannel recordings without
affecting the bass redirected from other speaker channels. The subwoofer adjustment changes both the redirected
bass and LFE levels. Also keep in mind that ARC will balance all channels to be equal and you should wait to adjust on-
the-fly settings until after running ARC.
Do not use these controls, intended for on-the-fly adjustments, for system calibration. System calibration should be
completed using Anthem Room Correction or the setup menu.