a-them AVM 90 Operating Manual page 48

Mode
Static IP settings take effect once this setting changes to "Manual."
Remote Control
This menu offers more advanced control settings.
IP Configuration
Device Name
TCP Port
Rear IR
Front IR
Tx Status
TCP Port
Change this only if there is a conflict with another application that uses 14999. Available settings are 1025 to 49150.
Rear and Front IR
This setting allows you to disable each of the MRX/AVM's infrared inputs, which can be useful when the MRX/AVM is
connected to an IR repeater and is receiving too many signals.
Note that after you disable the front and rear IR inputs, you can no longer control the MRX/AVM with the remote
control. You can re-enable the IR inputs using the front panel buttons. If your remote control is not working and you
have already checked the batteries, check this menu next before contacting technical support.
TX Status
Choose whether all commands, status changes, and control information report through the Ethernet and RS-232
connections or Ethernet only.
Trigger
When connected to the trigger input of another component, such as an amplifier or projector, the MRX/AVM's trigger
output can turn the connected device on or off according to the trigger's setup.
MRX 540
ITrigger Selection
Trigger Delay
Trigger Control
Power
Main or Zone 2
HDMI 1
Off
HDMI 2
off
eARC
Off
Streaming
Bluetooth
MAC
14999
Off
On
IP Only
None
Menu
Off
Off