Ebyte E70-915NW30S User Manual page 24

Chengdu Ebyte Electronic Technology Co.,Ltd
AT+ECHO Sets up the AT instruction to turn off the back display
AT+ECHO=Value
18
Example：AT+ECHO=1
Note： This setting only applies when the power is turned on. After the restart, the default settings are restored and the echo is enabled by default.
AT+VER Reading the version number
19
AT+VER
Example：AT+VER
AT+CLINFO Clearing network information
AT+CLINFO
20
Example：AT+CLINFO
Note: The network cannot be re-established after the module is cleared (this command can clear all the information when the number of
coordinator node devices reaches 50).
AT+TLCFG Setting/Querying the concurrency performance parameter (reboot valid)
AT+TLCFG=？
AT+TLCFG=value
21
Example: AT+ TLCFG =0
(Note: This parameter is mainly used to configure the concurrency performance of the module. That is, when various nodes concurrently
transmit data, the maximum number of nodes is supported. The higher the performance, the greater the number of concurrent systems, but the
delay in sending data. The average power consumption of the nodes will increase; the lower the performance, the higher the real-time
performance of the data sent by the nodes, but the data may be lost when the environment has large interference or multiple nodes transmit
simultaneously.)
Chengdu Ebyte Electronic Technology Co.,Ltd
Copyright ©2012–2019，
Description:
Value:0 or 1
1：Close the echo
0：Open the echo
Description:
Description:
Description:
Gets the concurrency performance parameter
Response：
TLCFG:0
Description:
Value:0~3
0：Low concurrency
1：Medium concurrency
2：High concurrency
3：Highest concurrency
E70-915NW30S User Manual
1-23