Ebyte E70-915NW30S User Manual page 17

915mhz 1w star network smd wireless module

Hide thumbs Also See for E70-915NW30S:

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd

shown in Figure 3:

Normal node configuration

Open the serial port assistant and select the serial port corresponding to the device. Set the baud rate to 115200, the

data bit to 8 bits, the parity bit to none, the stop bit to 1 bit, and the flow control is disabled, open the serial port.

Enter "+++" without line breaks to enter the AT command mode. When receiving "Enter AT Mode", the AT mode is

Enter "AT+HELP" with line breaks to see all instructions. As shown in Figure 4:

Then enter "AT+WMCFG=1" with line breaks to configure the device as the coordinator mode, as shown in Figure

Then enter "AT+RSTART" to restart the device with a line break. The coordinator configuration is complete.

As shown in Figure 5-6:

Chengdu Ebyte Electronic Technology Co.,Ltd

Figure 3

successfully entered.

Figure 4

Figure 5

E70-915NW30S User Manual

1-16

Table of Contents