Hardware Installation - ICP DAS USA I-7565M-HS Quick Start Manual

1
-----------------------------------------------------------------------

Hardware Installation

Before using I-7565M-HS device, some things must be done.
Step 1: Prepare one I-7565M-HS device
Step 2: Determine if the terminal resistor is needed or
not
Check the application structure, and determine if the terminal
resistor is needed or not. You can find it at the position as follows.
Copyright © 2018 ICP DAS Co., Ltd. All Rights Reserved.
Pin
Description
No.
ON: Active CAN1 terminal resistor
1 (default)
OFF: Inactive CAN1 terminal resistor
ON: Active CAN2 terminal resistor
2 (default)
OFF: Inactive CAN2 terminal resistor
E -mail: service@icpdas.com 2