Symbols - liniLED Diffuse G4 Manual

Symbols

Manufacturer's declaration that the product meets the applicable EC directives.
F Suitable for mounting on all surfaces and suitable to cover with insulating material.
Passed glow wire test at 850 degrees Celsius. Global European regulations specify 650 degrees Celsius by default.
GLOW WIRE
850 °C
Restriction of Hazardous Substances (RoHS): product complies with the RoHS directive and each homogeneous material does not exceed
the limits for the materials mentioned under the RoHS directive (Pb, Hg, Cd, Cr6+, PBB and PBDE).
RoHS
Dust-tight, no ingress of dust. Protected against the effects of continuous immersion in water
IP68 (immersion in water at a maximum depth of 50 metres). Only in combination with the liniLED® Mirror Welded Connector.
+
Dust- tight, no ingress of dust. Protected against close-range high pressure, high temperature spray downs.
Only in combination with the liniLED® Mirror welded connector.
IP69K
Protected against impact energy of 5 joules.
IK08
24
Operating voltage of 24 V DC.
V DC
Electrical appliance class III: this product is designed to be supplied from an extra-low voltage (≤ 60.0 V DC or ≤ 42.4 V AC).
Product is resistant against ultraviolet (UV) light or sunlight. Non-UV resistant products can degrade or discolour fast when exposed to UV light.
UV
Product can be cleaned with normal cleaning agents.
CLEANING
This product can be stored and used below 0 degrees Celsius. Verify the minimum storage and operating temperature in the datasheet or manual
for the lowest temperature allowed.
FROST
This product can be applied in seawater and its environment. Elements in seawater will have no harmful e ect on the product.
For chemical speci cations of these elements see the liniLED® material sheet. Verify the IP rating for proper use.
SEA
This product can be applied inside swimming pool environments. Elements in the air will have no harmful e ect on the product.
For chemical speci cations of these elements see the liniLED® material sheet. Verify IP rating for proper use.
SWIMMING POOL
ENVIRONMENT
This product is available on request and can be applied submerged in swimming pools and their environment. Disinfectants will have
no harmful e ect on the product. For chemical speci cations of these elements see the liniLED® material sheet. Verify IP rating for proper use.
SWIMMING POOL
SUBMERSIBLE
CRI
80 The CRI value of this product is 80 or higher.
+
White colour consistency up to 2 SDCM ellipse over an entire single strip length. LEDs used are single BIN 3 SDCM ellipse, but their careful
2
MAC
combination in a LED strip during the production process, results in a mixed light through a di usive material which is within a 2 SDCM ellipse
ADAM
(probability >90%). Due to variability this is not legally binding. The guaranteed colour consistency can be found in the technical speci cations.
S D C M
This product needs to be disposed of separately from normal household waste so it can be recycled. Verify the IP rating for proper use.
5
System guarantee of 5 years when the complete system consist of liniLED® products with the 5 years system warranty logo.
Terms & conditions apply.
System
11
Manual | liniLED® Diffuse