Advertisement
SZ P - 10 1
TYPE
Pole Attachment
① Install the Pole Waterproof Ring to the bottom of the Upper Bracket.
Check that the 2 ribs are on the outside.
② Insert the Pole into the Upper Bracket. Refer to the figure on the right.
(The Pole is sold separately. )
③ Tighten the Binding Head Tapping Screws (2 pcs.) from
the topside of the Upper Bracket.
Recommend
Screw
Torque
3×12mm
0.8 N･m
Product Attachment
□3-screw Mounting Type
① Wire the product as shown on the right.
② When use a Rubber Gasket (SZW-103), waterproofing is required.
(Refer to "Product Attachment (page 17)" for
the mounting method of the Rubber Gasket.)
③ Insert the product bolt into the mounting hole of the Upper Bracket.
④ Use the nuts and washer (accessory) to secure the product.
Model
Nut
SF10/SL10/SKH
M5
※ The Waterproof Sheet is not required.( Accessory of Upper Bracket )
□2-point Hole Type Mounting
① Wire the product as shown on the right.
② Using the mounting holes on the Upper Bracket, secure
the Mounting Bracket and Waterproof Sheet with screws and nuts.
(Installation screws and nuts are not included with this product. )
Recommend
Model
Screw
SF10/SL10/SKH
M5×20mm
③ Check that the O-ring is not twisted.
④ Align the indicators of the Mounting Bracket and the body of the beacon,
then twist clockwise to lock in place.
(Read the applicable instruction manual for the locked state.)
Recommend
Torque
1.4 N･m
Recommend
Torque
1.4 N･m
③
①
②
③
②
①
④
④
③
②
①
18
Upper Bracket
Pole Waterproof Ring
Pole
3-screw Mounting Type
Mounting Bracket
O-ring
Waterproof Sheet
(for Beacon)
Waterproof Sheet
(for Upper Bracket)
2-point Hole Type Mounting
Advertisement
