Advertisement
Product Attachment
□3-screw Mounting Type
① Attach the Wall Mount Bracket to the wall, referring to
the dimensions in the Mounting Dimensional Drawing below.
(Screws are not included. Please prepare separately.)
② If using a cable gland, refer to "Product Mounting
with Knock-outs (page 11)".
③ If using a Rubber Gasket (SZW-102 / SZW-103),
waterproofing is required.
(Refer to "Product Attachment (page 17)" for
mounting instructions for the Rubber Gasket.)
④ Wire the product as shown on the right.
⑤ Insert the product bolt into the mounting hole of the Wall Mount Bracket.
⑥ Use the nuts and washer (accessory) to secure the product.
Model
Nut
SF08/SL08/SKS
M4
SF10/SL10/SKH
M5
□2-point Hole Type Mounting
① Attach the Wall Mount Bracket to the wall, referring to
the dimensions in the Mounting Dimensional Drawing below.
(Screws are not included. Please prepare separately.)
② Using the mounting holes on the Wall Mount Bracket, secure
the Mounting Bracket and Waterproof Sheet with screws and nuts.
(Installation screws and nuts are not included with this product. )
Recommend
Model
SF08/SL08
M4×20mm
SF10/SL10
M5×20mm
③ Wire the product as shown on the right.
④ Check that the O-ring is not twisted.
⑤ Align the indicators of the Mounting Bracket and the body of the beacon,
then twist clockwise to lock in place.
(Read the applicable instruction manual for the locked state.)
■Mounting Dimensional Drawing［Unit：mm］
Recommend
Torque
0.7 N･m
1.4 N･m
Recommend
Screw
Torque
0.7 N･m
1.4 N･m
70
Mounting Hole
4 - 6
Wiring Hole
15
⑤
③
⑥
With Cable Gland
Recommend
Screw / Nut
Torque
M5
1.4 N･m
12
②④
Without Cable Gland
3-screw Mounting Type
Mounting Bracket
⑤
O-ring
Waterproof Sheet
④
②
2-point Hole Type Mounting
Rubber
Gasket
④
③
Advertisement
