Yard Machines 611 Operator's Manual page 7

Attaching Clutch Grips
(Use Hardware Group B.)
• Slide the pivot rod into the cover tube as shown in
Figure 3.
NOTE: In some models, the pivot rod and cover tube
may be pre-assembled.
Pivot Rod
Figure 3
• Place the clutch grips in position on the rod as
shown in Figure 4. Thread hex nuts (D) onto each
end of the rod. Tighten nuts allowing the clutch
grips to move freely on the pivot rod. See Figure 4.
Pivot Rod
with Cover
Hex Nuts D
Figure 4
• Insert clutch grip and rod assembly into handle
tabs. Clutch grips must sit on top of the handles.
Thread hex nuts (D) on each end to hold into
position. Do not tighten. See Figure 5.
Clutch Grip and
Rod Assembly
Figure 5
Attaching Handle Panel
(Use Hardware C.)
• Position the handle panel between handles. Insert
two carriage bolts (E) on each side and secure with
lock washers (C) and hex nuts (D). See Figure 6.
Cover Tube
Clutch
Grips
Handle
Tab
Hex Nut D
Carriage
Bolts E
Lock
Washer C
Self-Tapping
Screws F
Attaching Speed Selector Plate
(Use Hardware D.)
• Assemble the speed selector plate to the outside
of the handles as shown in Figure 6. Secure using
two self-tapping screws (F) on each side.
Attaching Shift Lever
• Insert the shift lever through slot in the speed
selector plate. See Figure 7.
NOTE: The bend in the lever should be towards the
operator.
Shift
Lever
Hex
Bolt G
• Secure shift lever to the shift lever spring using two
hex bolts (G) and hex lock nuts (H). Tighten both
7
Speed
Selector
Plate
Lock
Washer C
Carriage
Bolts E
Self-Tapping
Screws F
Figure 6
Speed Selector
Plate
Hex Lock Nuts H
Hex
Bolt G
Shift Lever
Spring
Figure 7