Buttons - ASCOM Care Phone GSM Programming And Installation Manual

Programming and Installation Manual
Care Phone
1.4

Buttons

Analog Care Phone / GSM Care Phone has three buttons on the top, all designed
to be easy to push on. The buttons are:
• Active Alarm (Red)
• Reset (Green)
• Present/Ready (Grey)
When you press the alarm button (or alarm transmitter) the Care Phone normally
waits for 10 seconds before the alarm is redirected. During this time, you hear an
alarm signal and the alarm can be cancelled by pressing the green button. Some
alarms ring silently, for example, technical alerts such as test alarms and the
battery alarm. These cannot be cancelled with the green button.
If you wish a Present/Finish function can be activated so that the grey button on
the Care Phone can be used to register when staff are currently with the care
recipient. (This is done via the hand terminal. The feature is found in the menu,
"Plus Alarm.") When the staff arrives to the care recipient, they notify this by
pressing the grey button on the Care Phone. When the button is pressed, the
alarm signal and present indicator light up on top of the Care Phone. When the
staff is ready to leave the care recipient, the grey button is pressed again and a
received signal is heard. In this way, information on the length of stay can be
collated in the system for each individual care recipient.
1.4.1 Button features
The table below describes the functions activated via buttons:
Control
Press the red button in normal mode
Press the red button when the phone is ringing
Press green button during the call
Press grey button during the call
Hold the green button down, press the grey and red.
Release on audio signal.
Hold the green button down, press the grey and red.
Release when the LEDs flash rapidly.
Hold the green button down, 2 press the red button
Hold the green button and red button down for 3 s
Press green button down during start-up
Hold red button down during start-up
Press the grey button in the transmitter programming
(2)
mode
Hold down the green button for three seconds
(1)
Requires that the feature is enabled in the Care Phone.
(2)
See instructions in section 5.2.
For a description of the functions in the programming mode, see section 5.2
17-July 2012 / Ver. B
Function
Alarm is activated
The call is connected
(1)
(1) Dialling of the alarm is cancelled
Present / Ready signal
(1)
Programming Mode
Restart
(1) Present / Ready
Manual, test alarm
Activate function test
(2) Programming mode of radio
transmitters
Deprogramming of radio
transmitter
(2) Away mode is activated /
deactivated
TD 92816EN
5