ASCOM Care Phone GSM Programming And Installation Manual page 30

Programming and Installation Manual
Care Phone
5.2.4 Change the speaker volume
You can easily change the speaker volume, even if you do not have a hand
terminal available.
• Press the green button and hold.
• Also press the red and grey buttons and hold them down until an ascending beep is
heard. You can then release all buttons.
• Now you are in the Care Phone programming mode, as indicated by the light switching
between the LEDs.
• Press the grey button down until you hear a beep. Then release the button.
• The Care Phone now gives off a number of beeps corresponding to the speaker
volume that is currently selected. The volume is adjustable between 1 and 8 beeps.
- To increase the volume: press the red button
- To decrease the volume: press the grey button
• Every time you press the grey or red button, the Care Phone speaker volume is
indicated by both the number of beeps and the adjusted volume level.
• When you are satisfied with the level, press the green button to save the settings.
• Then press the green button again to exit the programming mode.
5.2.5 Range test
The range test is designed to be able to test the range of the alarm transmitter
to ensure that it has range over the area you have in mind, such as the entire
area of the care recipient's apartment. The range test also provides information
as to the battery level of the alarm transmitter.
• Press the green button and hold.
• Also press the red and grey buttons and hold them down until an ascending beep is
heard. Then release all buttons.
• Now you are inside the programming mode, as indicated by the light switching
between the LEDs.
• Press the grey button down until you hear three consecutive beeps.
• Release the button and the Care Phone then replies with four beeps.
• With maximum 1 minute intervals, the alarm transmitter can now be tested.
- One short beep - means that the accessory is programmed and the battery is OK.
- One long beep - means that the accessory is programmed, but the battery level in
the accessory is low and needs replacing.
- Two short beeps - means that the accessory being used has not been programmed
for the current Care Phone but the alarm gets through and the battery is OK.
- Two long beeps - means that the accessory being used has not been programmed
for the current Care Phone, and the battery level in the accessory is low and needs
replacing.
• Remember to test the range everywhere in the apartment as there may be materials in
walls, etc. that obstruct the radio signal from the alarm transmitter.
17-July 2012 / Ver. B
TD 92816EN
27