Table of Contents
Advertisement
Programming and Installation Manual
Care Phone
4.2.4 Programming of Protocol
• When sections 4.2.2 and/or 4.2.3 are finished, continue according to the below:
Choose Protocol
press Yes
• Press
accept.
• Repeat the procedure for Protocol B, C etc. For each phone number entered in section
4.2.2, a protocol must be specified. The protocol for the addresses are below the
protocols for telephone numbers, but there is the protocol STT IPACS default.
• Press No to exit the menu "Protocol".
4.2.5 Programming of Sequences
The programming of sequences defines which alarm types shall call which alarm
receiver and in what order. (See table in Appendix A.) Follow the instructions
below:
Choose Sequences
press Yes
Preset value
• Use
or
value. The letters represent the listed phone numbers and addresses. If no telephone
number is required for the current position, enter "-".
• When settings are entered, press Yes.
• Repeat this procedure for the other sequences that you need.
• Press No to return to the "Sequencing" menu
17-July 2012 / Ver. B
Choose Protocol A
press Yes
or
until the protocol is shown in the "new value" field and press Yes to
Choose Def. sequence
press Yes
Choose new value
to switch between the ten values and positions and
TD 92816EN
Value STT has been
acquired
Choose Sequence 1
press Yes
or
to change the
18
Advertisement
Table of Contents
Need help?
Do you have a question about the Care Phone GSM and is the answer not in the manual?