Sharp AL-1217D Operation Manual page 55

A: When copying in a one-sided to two-sided mode:
B: When copying in the two-sided to two-sided mode:
C: When copying in the two-sided to one-sided mode:
3
Select the copy settings. See "SET THE COPY QUANTITY"
(p.49), "EXPOSURE ADJUSTMENT/PHOTO COPYING" (p.49),
and "REDUCTION/ENLARGEMENT/ZOOM" (p.51).
Using the original table
If you are using the original table, copying is only possible in one sided to
two-sided mode ("A" above).
1
2
Using the SPF/RSPF
Press the start (
1
2
3
4
Downloaded from:
Use the original to copy key to select the desired one-sided to two-sided
copying mode (Turn on Long Edge or Turn on Short Edge). See the
illustrations on page 52.
Use the original to copy key to select the two-sided to two-sided copying
mode. The originals must be set in the SPF/RSPF before this mode can
be set (step 3) on page 48 (AL-1555).
Use the original to copy key to select the two-sided to one-sided copying
mode. The originals must have been set in the SPF/RSPF in step 3 on
page 48 (AL-1555).
A
Press the start (
The original is scanned into the unit's memory.
Place the original that you wish to copy onto the rear side of the
paper, and press the start (
Copying begins.
) key. Copying begins in the selected two-sided copy mode.
http://www.usersmanualguide.com/
B
) key.
) key again.
C
6
53