Toro ProCore SR Series Service Manual page 37

Removal (Fig. 18)
1. Position aerator on a firm, level surface. If aerator is
attached to tractor, disengage PTO, apply tractor park-
ing brake, stop engine and remove key from the ignition
switch.
2. If necessary, remove rear hood:
A. Unlatch rear hood.
B. Remove two (2) cap screws (item 13) that secure
rear hood to frame.
C. Remove rear hood from machine.
3. To remove front screen (item 2 or 3):
A. Unlatch, raise and support rear hood if it is at-
tached to frame.
B. Support front screen to prevent it from falling.
C. Remove cap screws and lock washers that se-
cure top screen clip (item 6) and front screen bracket
(item 7) to frame.
D. Remove two (2) cap screws and lock washers
that secure front screen to frame channels. Retrieve
two (2) spacers (item 5) from between screen and
frame.
E. Remove front screen from machine.
4. If necessary, remove top screen clip (item 6) and
front screen bracket (item 7) from front screen.
ProCore SR Series
Installation (Fig. 18)
1. If removed, secure top screen clip (item 6) and front
screen bracket (item 7) to front screen.
2. To install front screen (item 2 or 3):
A. Position front screen to machine.
B. Place two (2) spacers (item 5) between screen
and frame. Install two (2) cap screws and lock wash-
ers to secure front screen to frame channels.
C. Secure top screen clip (item 6) and front screen
bracket (item 7) to frame with cap screws and lock
washers.
3. If removed, secure rear hood to machine with two (2)
cap screws (item 13).
4. Lower and secure rear hood.
Page 3 - - 19 Chassis