Roller (Procore Sr75) - Toro ProCore SR Series Service Manual

Roller (ProCore SR75)

FRONT
RIGHT
5
1. Aerator frame
2. Roller
Roller Removal (Fig. 6)
1. Position aerator on a firm, level surface with aerator
attached to tractor. Disengage PTO, apply tractor park-
ing brake, stop engine and remove key from the ignition
switch.
2. Support aerator to prevent it from moving.
3. Chock roller to prevent it from moving.
4. Loosen two (2) set screws that secure each bearing
locking collar to roller shaft (Fig. 7).
5. Remove four (4) cap screws and lock nuts that se-
cure flange bearings (item 4) to aerator frame.
Chassis
ANTISEIZE
3
LUBRICANT
4
Figure 6
3. Cap screw (4 used per bearing)
4. Flange bearing (2 used)
6. Start engine on tractor. Slowly raise aerator while al-
lowing roller assembly to remain on the ground. Stop
tractor engine and remove key from the ignition switch.
Support raised aerator to prevent it from lowering unex-
pectedly.
7. Remove roller with flange bearings from under ma-
chine.
Page 3 - - 6
1
2
5. Lock nut (4 used per bearing)
CAUTION
To prevent personal injury, make sure that roller
is supported as it is removed from the machine.
ANTISEIZE
LUBRICANT
ProCore SR Series