Toro ProCore SR Series Service Manual page 35

Removal (Fig. 17)
1. Position aerator on a firm, level surface. If aerator is
attached to tractor, disengage PTO, apply tractor park-
ing brake, stop engine and remove key from the ignition
switch.
2. If necessary, remove rear hood:
A. Unlatch rear hood.
B. Remove two (2) cap screws (item 2) that secure
rear hood to frame.
C. Remove rear hood from machine.
3. To remove front screen (item 5 or 6):
A. Unlatch, raise and support rear hood if it is at-
tached to frame.
B. Support front screen to prevent it from falling.
C. Remove cap screw, lock nut and two (2) flat
washers that secure front screen to screen clip (item
11).
D. Remove cap screw, lock washer and flat washer
that secure front screen to frame.
E. Remove two (2) cap screws and flat washers that
secure front screen to frame. Retrieve two (2)
spacers (item 9) from between screen and frame.
F. Remove front screen from machine.
ProCore SR Series
Installation (Fig. 17)
1. Make sure that screen clip (item 11) is loosely at-
tached to frame.
2. To install front screen (item 5 or 6):
A. Position front screen to machine.
B. Place two (2) spacers (item 9) between screen
and frame. Install two (2) cap screws and lock wash-
ers to secure front screen to frame.
C. Secure front screen to screen clip (item 11) with
cap screw, lock nut and two (2) flat washers.
D. Secure front screen tab to frame with cap screw,
lock washer and flat washer.
3. If removed, secure rear hood to machine with two (2)
cap screws (item 2).
4. Lower and secure rear hood.
Page 3 - - 17 Chassis