chains, saws for materials other than wood, pressure washers, etc.).
3. Do not allow these safety gloves to come into contact with pointed or
sharp objects (saw chain, metal tools etc.) or with aggressive
substances like animal excrement, acids, oil, solvents, fuel, etc., to
avoid damaging the material.
Contact with hot objects (muffler, etc.) and other sources of heat
(open fire, stove, etc.) should be avoided.
Caution!
If the safety gloves become contaminated by fuels, oils, grease or
other combustible or flammable substances while working, it is
essential to replace the gloves before doing any further work. Risk of
fire! Clean the gloves as instructed before wearing them again.
4. No repair possible.
If damaged, please discard immediately.
5. Criteria for discarding and disposal:
Safety gloves with a damaged surface or modified or damaged cut-
resistant inlay must no longer be used (loss of protective function!)
and must be disposed of immediately. Dispose of via the relevant
textile collection points (old clothes, recycling) or via general waste.
Duration and limits of use
We recommend replacing the product due to wear: in regular use
(several times per month) after max. 2 years. In occasional use, after
max. 5 years (also because of aging of the material)
6. The cut protection class indicates the chain speed during the test
according to standard conditions:
Class 0 = chain speed up to 16 m/s,
Class 1 = chain speed up to 20 m/s.
The higher the cut protection class, the greater the protective effect.
These safety gloves conform to
European Regulation 2016/425 and EN ISO 11393-4.
G
7
Need help?
Do you have a question about the FUNCTION Protect MS and is the answer not in the manual?