Zone 2; Zone 2 Connections - Yamaha RX-V1000 Owner's Manual

You can make up a multi-room audio-video system with this unit. This feature enables you to set this unit to reproduce
separate input sources in the main room and second room (Zone 2) with the supplied remote control in the second room.
Only analog signals are sent to the second room. For any source you want to listen to in the second room, you must
connect the analog output jack from the source to the corresponding analog input jack on this unit.

Zone 2 Connections

To use the multi-room functions of this unit, you need the following additional equipment:
• An infrared signal receiver in the second room
• An infrared emitter in the main room
This emitter transmits the infrared signals from the remote control in the second room to the main room
(for example, to a CD player or LD player).
• An amplifier and speakers for the second room
• A video monitor for the second room
OUT IN OUT
Example of a system configuration and connections
Main room
DVD player
(or other component)

ZONE 2

y
• Since there are so many ways to connect and use this unit in a
• Some YAMAHA models are able to connect directly to the
REMOTE
IN CONTROL OUT
This unit
This unit
Infrared emitter
REMOTE CONTROL OUT
multi-room installation, we recommend that you consult with
the nearest authorized YAMAHA dealer or service center for the
Zone 2 connections which will best meet your requirements.
REMOTE CONTROL OUT jack of this unit. If you own these
products, you may not need to use an infrared emitter. Up to 6
YAMAHA components can be connected as shown.
ZONE 2 VIDEO OUT
ZONE 2 AUDIO OUT
Second room
Amplifier
Video
monitor
Infrared signal receiver
Remote control
(in the Zone 2 mode)
REMOTE CONTROL IN
61