Track And Disc Erase (Cd-Rw Discs Only) - Yamaha CDR-S1000 Owner's Manual

RECORDING FUNCTIONS
Track and Disc Erase
(CD-RW discs only)
CD-RW discs can be erased and new recordings can be
made after material has been erased. The following types
of erasing are possible with this unit.
Last Track Erase
Erases the last track. This operation is not possible on a
CD-RW disc that has been finalized or when only one
track has been recorded on the disc.
All Track Erase
Erases all of the tracks recorded on the disc. This
operation is not possible on a CD-RW disc that has been
finalized.
TOC Erase
TOC Erase is only available on a CD-RW disc that has
been finalized. After the TOC is erased, the effects of
finalization are defeated, and further recording is possible.
Disc Erase
This operation deletes all data on the disc. It is usually not
necessary to perform this function, however, it may be
used to recover a disc that was stopped during a
finalization or erase operation, etc.
NATURAL SOUND CD RECORDER CDR-S1000
TRACK NO. EFFECT REC MODE
POWER FINALIZE ERASE DISPLAY
ERASE
TRACK NO.
REC MODE WRITE
EFFECT REPEAT RANDOM CLEAR
1
4
7
ERASE
FINALIZE
SEARCH
STOP
STOP &
E-21
REC LEVEL
INPUT DIGITAL/ANALOG
OPTICAL
COAXIAL ANALOG
REC
CD DIRECT REC
MUTE
MIN MAX
OPEN/CLOSE / / /
PHONES LEVEL
0 10
^ &
OPEN/
DIMMER DISPLAY CLOSE
PROG
2 3
INDEX
5 6 +10
8 9 0
ERASE REC REC MUTE
SKIP
PAUSE PLAY
PLAY #
To select an erase mode
Each time ERASE is pressed, the Erase mode changes as
follows.
CD-RW discs that have not been finalized:
Erase off = Last Track Erase = All Track Erase
Finalized CD-RW discs:
Erase off = TOC erase
All CD-RW discs:
Holding down ERASE for at least 2 seconds initiates
Disc Erase.
Note
• When there is only one track recorded on a CD-RW that has
not been finalized, only All Track Erase is possible.
IMPORTANT
• Do not turn off the power during an erase
procedure as this could cause the player to
malfunction and make the disc unusable.
• If the message "Check Disc" appears during an
erase operation and erasing stops, the disc may be
damaged. Should this occur, inspect the disc and
then try erasing it again.
Last Track Erase
1
Load a CD-RW disc that has been recorded on.
• This function is not possible on a finalized
CD-RW disc.
2
Press ERASE.
• "Erase LAST?", appears in the display.
• If you want to cancel the Erase mode, press &
(STOP & on the remote).
3
Press ^ (PLAY # on the remote) to start the Last
Track Erase process.
• This operation requires several seconds to
complete.
• During Last Track Erase, "Erase" and the
remaining time to completion appear in the display.
4
The recorder stops when Last Track Erase is
complete.
±