Juniper JCS 1200 Replacing Manual page 2

Installing a JCS 1200 Management Module or Module Filler
Related Topics
2
Installing a JCS 1200 Management Module or Module Filler
Figure 2 on page 2 shows how to remove and install a management module.
Figure 2: Removing and Installing a JCS 1200 Management Module
To install a management module or module filler (see Figure 2 on page 2):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
1.
connect the strap to one of the ESD points on the chassis.
Remove the management module filler, if one is installed.
2.
Remove the management module interposer filler tray, if one is installed.
3.
Install the management module interposer, if it is not already installed.
4.
Make sure that the release handle on the management module is in the open
5.
position.
Slide the management module into the management module bay until it stops.
6.
Push the management module release handle to the closed position.
7.
Connect any cables to the management module.
8.
If the JCS 1200 platform is connected to power, make sure that the OK LED on
9.
the management module is lit. If the management module is redundant, wait at
least 45 minutes for the modules to copy the configuration data before you make
any changes to the management module configuration.
Preventing Electrostatic Discharge Damage to the JCS 1200 Platform
JCS 1200 Management Module Description
Replacing a JCS 1200 Management Module Filler Tray
Locating the JCS 1200 Management Module Serial Number