Step 8: Network Settings; Make The Network Settings For The Computer - Roland VersaUV LEF-300 First Step Manual

Before Using This Printer

STEP 8: Network Settings

Introduction
Make sure the machine is connected to the network by an Ethernet cable.
The network settings on the machine must be made manually, using the operation panel. For information
about how to make the settings, refer to "Make the Network Settings on the Printer" (P. 41) later in this
step.
Also, to perform printing from this machine, the RIP & PRINT MANAGEMENT SOFTWARE included with the
machine must be installed on the computer you are using. For information about installation, refer to the
documentation for the RIP & PRINT MANAGEMENT SOFTWARE.
This machine has a built-in print server as a network interface. When you use the print server, you can send
print data to the machine from anywhere on the network. TCP/IP is used as the protocol.
NOTE
The examples used in the procedures for making the settings described in this section assume you are
using one computer and one machine. The procedures and setting values described here may not be
suitable for all operating environments.
If the computer you are using is connected to a number of networked devices or to the Internet, incorrect
settings may adversely affect the entire network. For detailed information about the settings, consult your
network administrator.

Make the Network Settings for the Computer

Procedure
1.
Log on to Windows as the "Administrator" or a member of the "Administrators" group.
2.
Windows 10
2-1.
From the [Start] menu, click [Settings], and then click [Network & Internet].
2-2.
Click [Network and Sharing Center].
2-3.
Click [Ethernet] or [Wi-Fi].
Windows 8.1
2-1.
From the [Start] menu, click [PC settings], and then click [Control Panel].
2-2.
Click [Network and Internet], and then click [Network and Sharing Center].
2-3.
Click [Ethernet] or [Wi-Fi].
38