Yamaha RX-V463 Owner's Manual page 57

Before performing the following operations, press
K SIRIUS.
■ All Channel Search mode
Press B SEARCH MODE (or M SRCH
1
MODE) repeatedly to select "ALL CH
SEARCH".
Press E PRESET/TUNING/CH l / h (or
2
8 PRESET/CH k / n) repeatedly to search
for a channel within all channels.
y
• You can search for a channel quickly by pressing and holding
E PRESET/TUNING/CH l / h
(or 8 PRESET/CH k / n).
• You can skip channels to the previous or next category by
pressing D CATEGORY (or 8 A-E/CAT. l / h).
■ Category Search mode
Press B SEARCH MODE (or M SRCH
1
MODE) repeatedly to select "CAT SEARCH".
Press D CATEGORY (or 8 A-E/CAT. l / h)
2
repeatedly to change the channel category.
Press E PRESET/TUNING/CH l / h (or
3
8 PRESET/CH k / n) repeatedly to search
for a channel within the selected channel
category.
y
You can search for a channel quickly by pressing and holding
E PRESET/TUNING/CH l / h (or 8 PRESET/CH k / n).
Note
This unit skips the channels when this unit is All Channel Search
mode or Category Search mode in the following cases (it is not
malfunction of this unit):
– the channel is locked (see page 54).
– the channel is out of service.
– you do not subscribe to the channel.
■ Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset SIRIUS channels. For details, see
"Setting the SIRIUS Satellite Radio™ preset channels" on
page 54.
Press B SEARCH MODE (or M SRCH
1
MODE) repeatedly to select "PRESET
SEARCH".
Press D CATEGORY (or 8 A-E/CAT. l / h)
2
repeatedly to change the preset channel
group (A to E).
Press E PRESET/TUNING/CH l / h (or
3
8 PRESET/CH k / n) repeatedly to change
the preset channel number (1 to 8).
y
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) ( G ).
■ Direct Number Access mode
Press M SRCH MODE on the remote control
1
repeatedly to select "ALL CH SEARCH" or
"CAT SEARCH".
2
Press the numeric buttons ( G ) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons ( G ) as shown below.
1
y
• To display the SIRIUS Radio ID (SID) number displayed in the
front panel display, select channel "0".
• To enter a one-digit or two-digit channel number, press the
numeric buttons ( G ) on the remote control and then press
T ENT to confirm the input number.
• Instead of pressing T ENT to tune into the channel
immediately, you can wait a few seconds until this unit confirms
the entered channel number.
• Pressing a button other than the numeric buttons ( G ) or T ENT
cancels the Direct Number Access mode procedure.
• If the selected channel is locked, "PIN:____" appears in the
front panel display. Enter the four-digit Parental Lock code
number by using the numeric buttons ( G ) or press T ENT to
cancel.
SIRIUS Satellite Radio™ tuning
2 3
53
En