Table of Contents
Advertisement
Available languages
Available languages
Note: Before installing, ensure proper radio contact between the
two devices!
Using
Press the door bell button (8) once. The LED indicator (7) lights
up. The transmitter transmits an impulse to the receiver. The
selected door bell chime sounds on the receiver.
Replace the battery of the door bell transmitter with a battery of
the same type if the receiver doesn't react on pushing the door
bell button any more.
Door Bell Receiver
Installation
The door bell receiver can be installed vertically or horizontally.
Screw in two screws in a distance of 6.4 cm and hang the receiver
on those screws to the wall.
Only install the door bell receiver indoors in a dry place that is
protected from dust, dirt and extreme temperatures.
Inserting/replacing the Batteries
1. Push down the battery compartment lid of the door bell receiver
and open the battery compartment.
2. Insert three new batteries of the type LR6 (AA) into the battery
compartment. Pay attention to the proper polarity of the batteries.
The polarity is printed inside the battery compartment.
3. Close the battery compartment with the lid.
4. Replace the batteries of the receiver with three new batteries of
the same type if the receiver does not respond to keystrokes any
more.
Note: Alternatively the door bell receiver can be powered by a
USB power supply (not included). Use the supplied mini USB
cable to connect the power supply to the mini USB interface on
the side of the housing.
Using
11
Advertisement
Table of Contents
