Connections; Audio/Video Source Equipment - Yamaha RX V2095RDS Owner's Manual

Connections

Caution: Plug in this unit and other components after all connections are completed.
All connections must be correct, that is to say L (left) to L, R (right) to R, "+" to "+" and "–" to "–". Also refer to the owner's manual for
each of your components.

Audio/video source equipment

Use RCA type pin plug cables for audio/video units with the exception described later.
The output (or input) terminals of YAMAHA audio/video units numbered as 1, 3, 4, etc. on the rear panel must be connected to
the same-numbered terminals of this unit.
Basic connections of audio units
CD player
MD recorder,
Tape deck, etc.
GND terminal (For turntable use)
(*1):
Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases
better results may be obtained with the ground wire
disconnected.
OUTPUT
AM
ANT
GND
LINE OUT
LINE IN
FM
ANT
75
UNBAL.
GND
(*1)
DIGITAL
RF SIGNAL
DVD/LD
Turntable
AUDIO SIGNAL AUDIO SIGNAL
PHONO DVD/LD
1
TV/DBS
CD
3
IN
( PLAY )
TAPE/MD VCR 1
4
OUT
( REC )
MAIN
VCR 2
SURROUND
EXTERNAL
DECODER
INPUT
SUB WOOFER CENTER
IN OUT
CD CD TAPE/MD DVD/LD
(PLAY) (REC)
COAXIAL DIGITAL SIGNAL
: Indicates the direction of signals.
PREPARATION
(Europe model)
VIDEO SIGNAL
VIDEO
S VIDEO
DVD/LD
TV/DBS
IN IN
VCR 1
OUT OUT
IN IN
VCR 2
OUT OUT
S VIDEO
MONITOR
OUT
OPTICAL
VIDEO
TV/DBS
15