Antennas - Yamaha RX V2095RDS Owner's Manual

PREPARATION

Antennas

Each antenna should be connected to the designated terminals correctly, as shown in the following figure.
Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal
strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor
reception quality only with the indoor antennas, the use of an outdoor antenna may result in improvement.
Outdoor FM antenna
Connecting the AM loop antenna
1. Press the tab and unlock the terminal hole.
2. Connect the AM loop antenna lead wires to the AM ANT and
GND terminals.
3. Return the tab back to the original position to lock the lead
wires. Lightly pull on the lead wires to confirm a good
connection.
24
Indoor FM
antenna
(included)
75-ohm/300-ohm
antenna adapter
75-ohm coaxial cable
75-ohm/300-ohm
antenna adapter
300-ohm flat ribbon
cable
1
3
2
Outdoor AM antenna
(Europe model)
AUDIO SIGNAL
PHONO
1
CD
3
AM
ANT IN
( PLAY )
TAPE/MD
GND
4
OUT
( REC )
FM
MAIN
ANT
75
UNBAL.
SURROUND
GND
EXTERNAL
DECODER
INPUT
SUB WOOFER CENTER
DIGITAL
RF SIGNAL
IN
DVD/LD CD CD TAPE/MD
(PLAY)
COAXIAL DIGITAL SIGNAL
4. Attach the loop antenna to the antenna stand.
Antenna stand
5. Orient the AM loop antenna so that the best reception is
obtained.
Notes
The AM loop antenna should be placed apart from the main
unit. The antenna may be hung on a wall.
The AM loop antenna should be kept connected, even if an
outdoor AM antenna is connected to this unit.
AM loop
antenna
(included)
OUT
(REC)
Ground
Loop antenna