Philips HFL4014 Series Installation Manual page 25

o Select the [Firmware Upgrade from USB]
menu and open it to go to the Software
Update Wizard
o If you are using an "autorun.upg" in the
root of your USB the TV will automatically
program the SW if it's newer than the
currently installed TV SW
o Using the Software Update Wizard, you
will be able to load new SW in the TV. You
will see the "autorun.upg" if it's on the
USB, you will also see a list of SW versions
that are available in the 'upgrades' folder
in the root of the USB device connected to
the TV if they are applicable for this
product
o Select the SW you want to install and press
"OK", you will see that the TV starts with
the downloading from USB to TV
o Once the downloading is done, you will see
that TV is restarting and installing the
system update. This can take several
minutes. Once installing is complete, the
TV will reboot
o Select the [Clone USB to TV] menu
o Using this you will be able to clone from
the USB device to the TV by selecting the
[MasterCloneData] and press "OK" to start
the cloning
o On the top of the page you will see a
waiting animation while
ongoing, once finished it will change to
Successful
o During the cloning process there will be a
[Cancel] button available on the bottom of
the page, press "OK" to cancel the cloning
process
o Once cloning is complete, [Cancel] will
change to [Close], press "OK" to return
back to TV state
o If no USB stick is inserted you will see USB
not found on top of the page
- 24 -
cloning is