Pedal - Arturia Phaser BI-TRON User Manual

4.3. Pedal

The Pedal is a controller that can be activated to control the Sweep Gen 1 frequency (instead
of the LFO), as well as to control the phase-shift sweeping of any of the two phaser engines
(independently).
The switch that activates the Pedal
controller in the Sweep Gen 1 section
To make it control the frequency, the Rate Ctrl switch must be in the Pedal position, as
illustrated above. When in the Manual position, the LFO takes control of the Sweep Gen Rate.
The switches that activate the Pedal controller in the two Phasor sections
To make the Pedal control the sweep of the phase-shifting of each engine, the respective
Sweep switch must be in the Pedal position. When the switch is in the Gen position, the
sweep is controlled by the Depth knobs.
Pedal signal-flow diagram
20 Arturia - User Manual Phaser BI-TRON - PHASER BI-TRON CONTROL PANEL