Summary of Contents for KVH Industries TracVision R6
Page 1
Azimuth Limit Switch Replacement Instructions Azimuth Limit Switch Replacement Instructions for TracVision ® The following instructions explain how to replace the azimuth limit switch in a TracVision R6. Estimated Time to Complete: 15 Minutes Tools Required • Phillips-head screwdriver Technical Support...
Page 2
TracVision R6 1. Turn off the antenna and disconnect power to all wired components. CAUTION To avoid bodily injury, be sure to turn off the antenna and disconnect power to all wired components. IMPORTANT To preserve the integrity of the radome’s weather sealing gasket, be sure to remove the radome slowly and gently.
Page 3
Azimuth Limit Switch Replacement Instructions 3. Disconnect the limit switch cable from the azimuth limit switch. Rotating Plate Limit Switch Cable Azimuth Limit Switch Screws (1 of 3) Limit Switch Cable/Screws 4. Using a Phillips-head screwdriver, remove the three screws securing the azimuth limit switch to the rotating plate.
Page 4
TracVision R6 5. Remove the azimuth limit switch. IMPORTANT To preserve the integrity of the radome’s weather seal, be sure to reinstall the radome slowly and gently. Ensure that the weather sealing gasket does not roll in any way while you are tightening the radome screws.