Installation Manual
4.3
Mounting
4.3.1
PR 6002/02S, ../03S
Note:
The following steps must be performed at all supporting points of the weighing
object (e.g. vessel)!
•
Put the mounting kit on the foundation (7) and tighten the bolts (5) lightly.
•
Place the weighing object (1) on the mounting kit and adjust the mounting kit position over the
bore holes.
•
Adjust the position of the washers over the bore holes so that the bore holes are covered.
•
Tighten the bolts (3) of the upper mounting plate (2) and the bolts (5) of the lower mounting
plate (6) with the recommended tightening moment, see Chapter 4.2.
•
Lift the weighing object (1) approx. 5 mm, a required lifting tool.
•
Clean the load cell base in both load disks.
•
Protect the contact surfaces between load cell/load disks with sufficient
•
Position and install the load cell (4) using the rubber ring for mounting, see Chapter 2.4.
•
Put the weighing object (1) again on the mounting kit, using a required lifting tool.
•
Remove the rubber ring, see Chapter 2.4.
Sartorius
Mounting Kits PR 6002
grease.
EN-19