Connecting The Power Supply Cord - Yamaha AX-397 Owner's Manual

CONNECTIONS

Connecting the power supply cord

■ Connecting the AC power supply cord
Plug the power supply cord into the AC wall outlet after
all other connections are complete.
■ AC OUTLET(S) (SWITCHED)
U.K. and Australia models ..................................... 1 outlet
Korea model .............................................................. None
Other models ........................................................ 3 outlets
Use these outlets to connect the power cords from your
other components to this unit. The power to the AC
OUTLET(S) is controlled by POWER or STANDBY/ON
on the front panel of this unit (or on the remote control).
The outlet(s) supply power to any connected component
whenever the power of this unit is turned on. For
information on the maximum power (total power
consumption of components), see "SPECIFICATIONS"
on page 18.
■ VOLTAGE SELECTOR
(Asia and General models only)
The VOLTAGE SELECTOR on the rear panel of this unit
must be set for your local main voltage BEFORE plugging
the power supply cord into the AC wall outlet.
Voltages are as follows:
Asia model.......................... AC 220/230–240 V, 50/60 Hz
General model ...... AC 110/120/220/230–240 V, 50/60 Hz
10
VOLTAGE SELECTOR
IMPEDANCE SELECTOR
A OR B: 4ΩMIN / SPEAKER
A+B: 8ΩMIN / SPEAKER
A OR B: 6ΩMIN / SPEAKER
A+B: 12ΩMIN / SPEAKER
AC OUTLETS
SWITCHED
100W MAX. TOTAL
To an AC wall outlet
AC power supply cord
(General model)