Connecting To Unit’s Output/Input Terminals - Yamaha YST-SW120 Owner's Manual

If your amplifier has two sets of speaker terminals
Right speaker
Connecting to this unit's OUTPUT/INPUT terminals
For connections, cut the speaker wires as short as possible. If
the connections are faulty, no sound will be heard from the
speakers. Make sure that the polarity of the speaker wires is
correct, that is, + and – markings are observed. If these wires
are reversed, the sound will be unnatural and will lack bass.
Do not let the bare speaker wires touch each other and do
not let them touch the metal parts of this unit as this could
damage this unit, your amplifier and/or speakers.
How to Connect:
Red: positive (+)
Black: negative (–)
2
1
3
6
This unit
OUTPUT INPUT2 PHASE
TO SPEAKERS
NOM REV
FROM AMPLIFIER
INPUT1
To AC outlet
A B
Unscrew the knob.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Tighten the knob and
secure the wire.
OUTPUT INPUT2 PHASE
TO SPEAKERS
NOM REV
FROM AMPLIFIER
INPUT1
(Both " A"and " B" outputs
must be ON.)
* Banana Plug connections are also possible (except for
Scandinavian model). Simply insert the Banana Plug
connector into the corresponding terminal.
Left speaker
Amplifier