Connecting To The Input1/Output Terminals Of The Subwoofer - Yamaha NS-SW300 Owner's Manual

WARNING
To avoid accidents resulting from tripping over loose speaker cables, fix them to the floor.
Always fix the speaker cable to a wall or similar. If you catch your feet or hands on the cable,
the speakers may fall or overturn, causing malfunctions or injuries.
NOTE
• Make sure that the "+" and "–" polarity markings of the speaker cables are observed and set
correctly. If these cables are reversed, the sound will be unnatural and lack bass.
• Do not let the bare speaker wires touch each other, because this could damage the subwoofer
or the amplifier.
• If the connections are faulty, no sound will be heard from the subwoofer or the speakers. Do
not insert the insulation into the hole. Sound may not be produced.
Before connecting
Remove the insulation at the tip of the speaker cable, then twist the core wires together so
that they will not become disarrayed and short-circuited.
NS-SW300
Remove about 15 mm (5/8") of insulation.
NS-SW200 Remove about 10 mm (3/8") of insulation.
9 En

Connecting to the INPUT1/OUTPUT terminals of the subwoofer

15 mm /
10 mm
Good No Good
How to connect
NS-SW300
Loosen the terminal's knob, as shown in the figure.
1.
Insert the bare wire.
2.
Tighten the knob.
3.
Test the firmness of the connection by pulling lightly
4.
on the cable at the terminal.
NS-SW300 (U.S.A., Canada and Australia
models only)
Connecting the banana plug
1.
Tighten the terminal knob.
2.
Simply insert the banana plug into the terminal.
NS-SW200
Press and hold the terminal's tab, as shown
1.
in the figure.
Insert the bare wire.
2.
Release your finger from the tab to allow it
3.
to lock securely on the cable's wire end.
Test the firmness of the connection by
4.
pulling lightly on the cable at the terminal.
2
1
Red:
positive (+)
3
Black:
–
negative ( )
1
2
2
1 3