Grandstream Networks GWN7000 Management & Provisioning page 14

VLAN ID
Enable IPv4
IPv4 Static Address
IPv4 Subnet Mask
DHCP Enabled for IPv4
DHCP Start Address
DHCP End Address
DHCP Lease Time
DHCPv4 Options
DHCPv4 Relay Enabled
Enable IPv4
IPv6 Relay from WAN
DHCP Enabled for IPv6
IPv6 Prefix for Assignment
IPv6 Subnet Hint
IPv6 Uplink
Enable Landing Page
Landing Page URL
Set a VLAN ID. Valid range is between 2 and 4093.
Check to enable IPv4 addressing for this network group
Set a static IPv4 address for the network group when enabling IPv4.
Set the Subnet Mask.
Check to enable DHCP using IPv4. This will allow clients connected to this
network group to get IPv4 addresses automatically from GWN7000 acting
as DHCP server.
Set the starting IPv4 address for this network group's clients.
Set the ending IPv4 address for this network group's clients
Set the lease time for DHCP clients users can set the value in hours,
minutes, or as "infinite". Default lease time is "12h".
Set the DHCP options. Click on
an option. Example: 44,192.168.2.50 for DHCP option 44 and
192.168.2.50 is the WINS server's address.
Please refer to the following link for DHCP options syntax:
https://wiki.openwrt.org/doc/howto/dhcp.dnsmasq
Enable this option, if you want the GWN7000 relays the DHCP requests
from clients to another DHCP server(s).
Once checked Click on
to delete a DHCPv4 Relay Target.
Check to enable IPv6 addressing for this network group.
Check to allow GWN7000 to relay IPv6 DHCP request from network
group's clients to WAN port.
Check weather to enable IPv6 DHCP server for this network group.
Set the prefix value to be assigned to the network group. Valid range is
between 1 to 64.
Example: 64 will assign /64 prefixes.
Set the subnet mask value.
Select the WAN port.
Check to enable landing page when connecting to this network group's
Wi-Fi.
Set the landing page URL to which clients will be redirected once
connected to the network group's Wi-Fi.
GWN7000 Controller
GWN76xx Wireless AP Management & Provisioning
to add another option, and
to add another DHCPv4 Relay Target, and
to delete
P a g e | 14