Yamaha NX-SW10 Owner's Manual page 9

Connecting the Subwoofer to the VS-10
Connect the SYSTEM CONNECTOR terminal on the VS-10 (sold separately) to the SYSTEM CONNECTOR terminal on
the subwoofer using the system connector cable.
Match the mark on the plugs with those on the terminals and insert the plugs.
VS-10 (sold separately)
VIDEO SIGNAL
MONITOR
OUT
DO NOT CONNECT THIS UNIT TO
SPEAKERS OTHER THAN NX-VS10M
DIGITAL 1 VIDEO 1 TV
(V/PCM)
INPUT
Notes
• Do not scratch, forcibly bend, or pull the system connector cable as this may damage the cable, causing loss of audio output, and possibly
result in fire or electric shock. Take particular care that the cable is not squashed by a rack or caster.
• When you disconnect the plug of the AC power supply cord of the subwoofer, turn off the power of the VS-10 beforehand.
• When you use only the VS-10 (sold separately) without using this system, disconnect the plug of the AC power supply cord of the
subwoofer and the system connector cable beforehand.
y
• When the power of the VS-10 is turned off, that of the subwoofer is also turned off accordingly.
Connecting the AC Power Supply Cord
REAR, CENTER SPEAKERS
MARK + +
– –
DO NOT CONNECT THIS UNIT TO
SYSTEM SPEAKERS OTHER THAN NX-VS10E,
CONNECTOR NX-VS10C
MAINS
Supplied
+ – – +
system
connector
MARK
cable
MAIN SPEAKERS
To SYSTEM
CONNECTOR terminal
SYSTEM
OUT
CONNECTOR
SUBWOOFER
Match the
with the
and insert.
To an AC outlet
To SYSTEM
CONNECTOR
terminal
mark on the plug
mark on the terminal
Once all connections have been made, check them one more
time. Finally, insert the plug of the AC power supply cord of
the subwoofer into an AC outlet.
CONNECTIONS
REAR, CENTER SPEAKERS
MARK
+ +
– –
DO NOT CONNECT THIS UNIT TO
SYSTEM SPEAKERS OTHER THAN NX-VS10E,
NX-VS10C
CONNECTOR
5