Yamaha NX-SW10 Owner's Manual page 8

CONNECTIONS
Connecting the speaker cords to the speaker terminals on the subwoofer
Bare wire
Connecting the speaker cords to the speaker terminals on the center
speaker and the rear speakers
3
4
3
1
Tab
2 2
2
Bare wire
Tab
1
1
Open the tab for the + terminal (red) or the –
terminal (black).
2
Insert the bare wire of the speaker cord into
the hole.
3
Return the tab until it clicks.
• Connect the line-in cord to the + terminal (red), and the
other cord to the – terminal (black).
• Once connected, pull gently on the speaker cords to
check that they are connected securely.
CAUTIONS
• Do not let the bare speaker wire touch each other and
do not let them touch any metal part of the speakers.
This could damage the speakers.
• Do not mistakenly connect positive (+) to negative(–)
or vice versa when connecting speaker cords.
• Insert the speaker cords securely so that positive (+)
and negative (–) do not short. The speaker may not
output any sound or may output noise, causing damage
to the speakers, if speaker cords are not inserted
securely.
• Only insert the bare wire portion of the speaker cords
into the holes. Sound will not be output if you insert as
far as the plastic insulation part of the cord.
• Secure the speaker cords so that they will not catch on
hands or feet.
1
Hold down the tab.
2
Insert the bare wire of the speaker cord into
the hole.
3
Release the tab. (The tab will return to its
original position when you release your
finger.)
• Connect the line-in cord to the + terminals (red) on the
right, and the other cord to the – terminals (black) on the
left.
• Once connected, pull gently on the speaker cords to
check that they are connected securely.