Configure Sites - Seagate Lyve Drive Shuttle User Manual

Configure sites
Some of the sites you connect to may require static IP addresses rather than Dynamic Host Configuration
Protocol (DHCP). Lyve Drive Shuttle walks you through adding network information for sites using static IP
addresses. Once a site is configured, you can
Home screen.
To add a site:
1. On the Network screen, tap Configure Sites.
2. Tap Add site.
3. Follow the onscreen prompts to create the following:
Site name
Fixed IP address
Subnet mask
Router address
Hostname
4. Tap Create to complete the site configuration.
To edit an existing site:
1. On the Network screen, tap Configure Sites.
2. Tap on the name of an existing site.
3. Follow the onscreen prompts to revise data.
4. Tap Create to complete the site configuration.
Set creden als (Volume password)
Add an extra layer of security by creating a username and password to access the Lyve Drive Shuttle volume
on the network. This is only available with SMB as the service and cannot be used with NFS. The default
name of the volume is Lyve Drive Shuttle.
To add or edit credentials:
1. On the Network screen, tap Set Credentials.
2. The device password is required to edit network credentials for Lyve Drive Shuttle's volume. Enter the
device password and tap Next.
3. Tap on the Username field and then use the keyboard to enter a username.
4. Tap on the Password field and use the keyboard to enter a password.
5. Tap Create.
6. Review the newly created credentials on the Network Credentials screen. You can also edit or delete
users on this screen.
Seagate Lyve Drive Shuttle
choose it when selecting a network connection from the
4/20/20 19