Connecting To Computer Devices - Yamaha DPX-1100 Owner's Manual

Connecting to computer devices

You can use the following two methods to connect to computer devices. Be sure to use cables with jacks that match the connectors and jacks
you wish to use.
Input
INPUT A
INPUT B
RGB/YP
+
-
(GND)
Signal type
RGB (Analog)
RGB (Analog)
HDMI
INPUT B INPUT A
P /YC C D4 VIDEO G/Y B/P /C R/P /C
B R B R B B R R
D-Sub monitor
cable
Monitor output terminal
Information for installers
(for US model only)
polarity (inside)
polarity (outside)
-
polarity
+
polarity
BNC jack x 5
D-sub 15 pin
OUT IN
RS-232C TRIGGER OUT
REMOTE
HD/SYNC VD S VIDEO VIDEO
BNC monitor cable
Computer devices
Use the supplied trigger-out DC plug to control external
components.
Be sure to solder the wires from an external component to the
plug terminals with the correct polarities, as illustrated at left.
Warning
• Soldering the wires to terminals with incorrect polarity may
cause bodily injury or may damage this unit and the
external component connected to this unit with this cable.
Connector type
9
47