Connection - Yamaha DPX-1100 Owner's Manual

N Setup
Location
Keystone Correction
Remote Control Sensor
Remote Control ID
Lens Adjustment Lock
Lamp Power
Menu Color
Menu Mode
Message
Trigger Out
Baud Rate
Designate the location of the main unit.
Choices: [Front/Table] [Front/Ceiling] [Rear/Table] [Rear/Ceiling] ( page 48)
Adjusts the projection angle of the image.
If you do not install the projector at right angles to the screen, the image will be trapezoidally
distorted. You can electronically correct this distortion using the keystone function to adjust the
width without changing the height of the image. Increase the keystone value (0 to 100) when the
top of the image is overly wide, and reduce it (-100 to 0) when the lower part is overly wide.
When the upper part of
the image is wider than the lower
Increase the value
in the positive (+) direction
Sets the remote control sensor.
The main unit has two remote control sensors, one on the front panel and one on the rear,
which this setting allows you to switch between. The remote control functions regardless
of the setting of this parameter if you use a wired connection to connect it to the main unit.
Choices: Front & Rear/Front/Rear/Off
Sets the remote control ID.
The main unit can receive commands from the remote control if you set the same ID in the main
menu as the remote control code switch on the side of the remote control is set to. Use this remote
control code switch to allow one remote control to control two main units independently.
Choices: ID1/ID2
Locks the lens adjustment function.
Locks the lens so that you cannot change the V.POS, ZOOM, and FOCUS settings
accidentally when set to [ON]. Set to [OFF] to cancel this function.
Lowers the power supply to the lamp.
You can adjust the power supplied to the lamp within the range of 80 to 100%.
Selects the color of the letters and background the main unit uses to display
the menu on screen.
You can choose to display the menu screen in [Monotone] or [Color]. Also, you can adjust
the contrast and brightness of the menu from the [Menu Brightness] and [Menu Contrast]
menus. You can select from 3 color types.
Monotone Menu Brightness
Menu Contrast
Switches menu modes between an easy-to-use basic mode and a detailed
advanced mode.
Choices: Basic/Advanced
Selects whether to display memory number, input signal and other
information on the projection screen. ( page 58)
Choices: On/Off
Sets the TRIGGER OUT terminal.
Set the external control TRIGGER OUT jack 12 V signal emission to [Lamp] to
synchronize it to the ON/OFF state of the lamp, to [Fan] to synchronize it to the fan, and to
[RS-232C] to receive ON/OFF signals through the RS-232C terminal.
Choices: Lamp/Fan/RS-232C
Sets the transmission speed of the RS-232C terminal.
This setting becomes valid from the next time you switch the unit on.
Choices: 9600bps/19200bps/38400bps/57600bps/115200bps
Menu items
When the lower part of
the image is wider than the top
Decrease the value
in the negative (-) direction
Color Menu Brightness
Menu Contrast
Color Style
7
31