Keypad And Display/Keyboard Module Re-Assembly - Motorola Commercial Series Basic Service Manual

7-10 Limited Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
4. Ensure the speaker is seated flush in the housing.
5. Insert the speaker retainer tab into the slot in the front housing (see
Note: When fastening the speaker retainer screw, make sure the wires are out of the way to
prevent pinching by the retainer.
6. Install the retainer screw using a T6 Torx screwdriver. Torque to 2.3 - 2.5 lb/in.

7.4.3.3 Keypad and Display/Keyboard Module Re-assembly

1. Remove the protective mylar liner from the housing lens, if present.
2. Place the new keypad into the housing.
3. With equal pressure over the keypad area, press the sealing rib into the mating groove in the
housing.
4. Press hooks on the keypad into the slots in the housing.
5. Remove the protective mylar liner from the LCD, if present.
6. Place the Display/Keyboard Module into the housing by positioning the LCD glass to the display
frame (see Figure
Display/Keypad Module
Keypad hooks
7. Use the two keypad posts to align the Display/Keyboard Module.
8. Screw in the two screws along the top first, followed by the two screws on the sides. Torque to 1.7
lbs/in.
9. Press in the two tabs at the bottom edge of the module into the two catches along the bottom sur-
face of the housing (see
December, 2009
7-13).
Figure 7-13. Display/Keypad Module Re-assembly (1)
Figure 7-14).
Figure 7-12).
Keypad Retainer
Keypad Retainer tabs
Keypad
68009328001-A