Table of Contents
Advertisement
2. Make sure that the charge LED lights-up yellow or green, and that the operation LED starts
blinking. If not, review the installation procedure, or see section
3. Go
to
Start\All-Programs\ABC_Instruments\Instrument_Manager,
Instrument_Manager.exe.
4. The front-panel described in
instrument. If it fails to find the instrument it indicates No Device Found. If this is the case see
section
Troubleshooting
5. Otherwise the application immediately starts communicating with the ABC Mems.
8.2
Main Functions
The application has five main tabs:
•
The Setup Tab:
Figure
9).
•
The Records Tab:
(see
Figure
10).
•
The Spectrum Tab:
(see
Figure
11).
•
The Static Tab:
calibration against the acceleration of gravity (see
•
The WiFi Tab:
and to setup its connection parameters (SSID, Security, Password...etc.) (see
8.3
Setup Tab
The setup tab is seen in
Figure
8.3.1 Time and Date Field
This field displays the internal time of the instrument. If the instrument time is not properly adjusted,
press Synchronize. This synchronizes precisely the instrument time to the PC time. Make sure the PC
time is accurate before synchronizing the instrument.
This field is also used to finely adjust the precision of the internal clock, if necessary.
Note:
Time synchronization is not allowed while the instrument is recording.
8.3.2 Temperature Field
This field is used to display the instrument's internal temperature in °C or °F. It is normal for the internal
temperature to rise slightly while the instrument is charging.
8.3.3 Instrument Info Field
The instrument info field provides instrument information, such as instrument model, serial number and
firmware revision. In addition the User-ID field may be used to assign a custom identifier to the
instrument.
User's Manual
Figure 9
appears, and the application tries to connect to the
Is used to setup the instrument and monitor real-time signal (see
Is used to download, display and export the data from the meter
Is used to display a real-time power spectrum from the meter
Is used to display static acceleration, inclination, and to check
Is used to display the present connection state of the meter
9. It is divided into seven fields.
Troubleshooting.
and
Figure
12).
run
Figure
13).
23
Advertisement
Table of Contents
