Page 1
All Rights Reserved. Copyright in the whole or any part of this document belongs to ABC and may not be used, sold, transferred, copied or reproduced in whole or in part in any manner or form or in or on any media to any person without the prior written consent of ABC.
It is therefore not recommended to drop or throw the 4T2. It should also be avoided to expose the instrument to high humidity, or water in it's liquid form. Shall you plan to store the 4T2 in that kind of conditions, ABC recommends to do so in the supplied flight-case or carrying bag.
At end of life time the device may be completely recycled. Any re-cycling organisation may separate the material without taking into account special safety regulations. 4T2-Portable Manual EN.odt / First steps Page 4...
All safety regulations and accident prevention instructions according to the specific operation scenario have to be observed. Opening of the 4T2-Portable is not allowed and voids the warranty. Regular checks have to be done in order to verify that the power cable connected to the instrument is in good condition.
Installation of not approved third party hardware may damage the 4T2 and is not being covered under the 4T2 warranty. We recommend to consult ABC, if in doubt of compatibilities of hardware. Opening of the 4T2 voids the warranty. There are no user serviceable parts inside the 4T2.
Depending on configuration, it performs DVB-T/T2, T-DAB(+), DVB-S/S2, and ASI or UDP measurements as specified in the relevant standards (see technical specifications). The 4T2-Portable offers the following functions through the 4T2 Content-Analyser application. ASI and IP inputs: Transport Stream level measurements ...
Page 8
Although described in this manual, your instrument may not be equipped with all these features as some (like the satellite receiver input) are optional. 4T2-Portable Manual EN.odt / Product overview Page 8...
After unpacking your 4T2, please engage the two latches on each side of the screen cover in order to release the keyboard. Table 1: Opening the 4T2-Portable Test Set The keyboard is used to protect the TFT display in transport mode; before performing any measurements release the keyboard as described above.
Calibrated antennas for fixed and portable reception are available as an accessory to use your 4T2 for field- or portable indoor measurements. Horizontal as well as vertical polarised antennas are available. (products supplied by Schwarzbeck Messelektronik) 4T2-Portable Manual EN.odt / Accessories Page 11...
The above mentioned product is in compliance with the following European standards: Electrical Safety EN 60950-1:2001 ETSI EN 55022:2001-09 ETSI EN 55024:2001-11 ETSI EN 55013:2003-10 (partly) ETSI EN 61000-3-2:2001-12 Low Voltage Directive 73/23/EWG Michelstadt Germany, 01.04.2019 Frank Wenzl 4T2-Portable Manual EN.odt / Miscellaneous Page 20...
7.2 Maintenance and calibration The 4T2-Portable has been designed as a robust test unit, which under any circumstances should not require special maintenance routines. We do, however, recommend sending your receiver to ABC to undergo a calibration procedure in defined intervals. This will ensure continuously high precision measurement results.
All Rights Reserved. Copyright in the whole or any part of this document belongs to ABC and may not be used, sold, transferred, copied or reproduced in whole or in part in any manner or form or in or on any media to any person without the prior written consent of ABC.